Vertical TeleVantage 7.5 Install Manual page 109

The default values that appear in the Experimenter are the E&M supervisory signaling
protocols. If your Robbed Bit T1 line supports a supervisory signaling protocol other than E&M,
you might need to modify events using information provided by your carrier. If you ordered
ANI/DID/DNIS services on your Robbed Bit T1 line, you must customize the event signaling
for digit collection.
To use the Robbed Bit T1 Experimenter
1.
2.
3.
4.
5.
6.
C 7. I
HAPTER NSTALLING
Make sure the Intel Dialogic drivers are started.
Start the Robbed Bit T1 Experimenter by choosing
TeleVantage > TeleVantage Robbed Bit T1 Experimenter
Note:
The Robbed Bit T1 Experimenter starts only if you have a T1 trunk board and
an MSI board installed on your PC.
If you have more than one T1 board installed in your PC, select which board to
configure. Click
Options > Analyze Board > Board n
board you want to configure. The T1 Board with the lowest ID number is selected by
default.
Click
File > Load Template
have a long-distance T1 trunk, select
The template loads configuration information that will be valid in most cases.
On the Basic tab, make sure the wink definition described under
matches the wink definition of your T1 carrier. Most carriers toggle the A
definition
and B bits for a wink, and most use a wink length in the 150-400 ms range.
Under
Send/receive digit type,
your carrier uses.
I D B
NTEL IALOGIC
. If you have a local T1 trunk, select
longdistance.dst
choose DTMF or MF, depending on the type of digits
D
OARD RIVERS
Start > Programs > Vertical
.
, where n is the number of the
local1.dst
.
Transmit wink
. If you
7-37