Table of Contents
Advertisement
A
F
PPENDIX
A
F
PPENDIX
C
HANGING THE
DM3 T
ELEPHONY
This appendix describes how to change the media load assigned to an Intel Dialogic DM3
telephony board. The media load defines the resources supported by the board.
You initially assign a media load to a DM3 board when it is first detected by the Intel Dialogic
Configuration Manager (DCM), as described in "Assigning firmware files to DM3 boards" on
page 7-14.
To change the media load for a DM3 board
1.
2.
3.
4.
M
Stop the Intel Dialogic Service via DCM. See Appendix D for instructions.
In the main DCM dialog box, right-click the board and then click
. Click
at the confirmation message.
Defaults
Yes
In the Assign Firmware dialog box, select the file to assign to the board from the
list, referring to the
Available Firmware
dialog box to identify the file that supports the features that you need.
There may be several firmware files that provide different numbers or combinations
of resources. For more information to help you choose between the available firmware
files, see Appendix E, "Intel Dialogic Telephony Board Specifications."
Note:
Be sure to select from the firmware files starting with "@", the versions
supported by TeleVantage. The versions without the "@" are raw files without
TeleVantage-specific features.
Click
, and then restart the Intel Dialogic Service.
OK
L
EDIA
OAD FOR A
B
OARD
Firmware Description
Restore Device
at the bottom of the
Advertisement
Table of Contents
Troubleshooting
