Table of Contents
Advertisement
Configuring Internet telephony boards
Perform the steps in this section only if you have one or more Internet telephony boards
installed.
Specifying the IP address, subnet mask, and gateway IP address
For each DM/IPx board, perform the following steps:
1.
2.
3.
4.
5.
6.
If you have digital station boards, go to the next section. Otherwise, perform any other required
board-specific configuration steps described in the table on page 7-19. When you are done, go
to "Test-starting the Intel Dialogic drivers" on page 7-33.
7-28
Start the Intel Dialogic Configuration Manager (DCM) if it is not already running. See
See Appendix D, "Using the Intel Dialogic Configuration Manager" for instructions.
In the DCM main dialog box, double-click the first IP telephony board.
Click the Network tab.
Complete the following required fields. See your network or system administrator for
the values to enter.
Q
For
, enter the static IP address assigned to the network interface card
IPAddress
(NIC) attached to the Internet telephony board.
Q
For
, enter the network's subnet mask.
SubnetMask
Q
For
GatewayIPAddress
Click
.
OK
Repeat for each additional IP telephony board.
, enter the IP address of your router.
I
NSTALLING
I
T
C
NTEL
ELEPHONY
OMPONENTS
Advertisement
Table of Contents
Troubleshooting
