Table of Contents
Advertisement
7.
8.
9.
Audio problems on conference calls on MSI/x-GBL boards
Some sites may experience a problem with noise generated as a conference call progresses.
Alternate firmware is available that fixes this problem.
Note:
Instead of noise, other sites may notice an echo that worsens during the conference call.
For those sites the normal firmware installed with the Intel Dialogic drivers is recommended.
To install the alternate MSI firmware
1.
2.
3.
4.
DSIx board drivers do not start
The DSIx board drivers will not start until you have configured the digital phone family on at
least one DSIx board according to the instructions on page 7-29.
No audio or one-way audio on calls on DSIx boards
If you are experiencing audio problems on calls on DSIx boards and are using an H.100 bus, do
the following:
1.
2.
3.
4.
5.
6.
7.
A
C. T
PPENDIX
ROUBLESHOOTING
Repeat for each additional D/120JCT-LS board.
Exit DCM.
Restart the Intel Dialogic drivers and the TeleVantage Server.
Stop the TeleVantage Server, if it is running.
Back up the existing MSI firmware file so that you can revert to it if necessary. The
default location is
C:\Program Files\Dialogic\Data\msi240.fwl
Copy the new MSI firmware file from the Intel Dialogic CD:
Drivers\Support\MSIFirmware_FR32\msi240.fwl
Restart the TeleVantage Server.
Stop the Intel Dialogic drivers for DSIx boards if they are running (see page 7-34 for
instructions.)
In the Intel MEA Configuration main dialog box, on the Telephony tab, right-click the
first DSIx board, and then select
On the TDM Bus Configuration tab, select
box. Then, select
8.192
Click
to save your change.
OK
Repeat for any additional DSIx boards installed on the TeleVantage Server.
Exit the Intel MEA Configuration main dialog box.
Restart the Intel Dialogic drivers for DSIx boards.
Configure Device
SCBus Clock Rate
from the
drop-down list.
Value
.
.
at the top of the dialog
C-13
Advertisement
Table of Contents
Troubleshooting
