Table of Contents
Advertisement
To verify the audio format configured on your system
1.
2.
3.
4.
To test-start the Intel Dialogic drivers for DSIx boards
Perform these steps if you have one or more DSIx boards installed. Note that the DSIx board
drivers will not start until you have configured the digital phone family on at least one DSIx
board according to the instructions on page 7-29.
1.
2.
3.
To test-start the Intel Dialogic drivers
1.
2.
7-34
In the DCM main dialog box, under
Select
Media Type (User Defined)
Select the correct audio format for your location from the
for North America and Japan, or
MuLaw
Click
. You only need to perform this check once—you do not need to recheck the
OK
audio format whenever DCM starts.
From the Start menu, choose
Boards > Configuration Manager
opens.
To start the Intel Dialogic digital station board drivers, click the green button on the
toolbar, or choose
Service > Start Service
The MEA Device Service Status displayed at the bottom of the dialog box changes to
"Running" after the drivers have started.
If you encounter a problem, see "Troubleshooting Intel Dialogic board problems" on
page C-1.
When you have verified that the Intel Dialogic digital station board drivers start
successfully, stop the drivers. To do so, click the red button on the toolbar, or choose
Service > Stop Service
Start the Intel Dialogic Configuration Manager (DCM) if it is not already running, and
then start the Intel Dialogic drivers. See Appendix D, "Using the Intel Dialogic
Configuration Manager" for instructions.
The System Service Status displayed at the bottom of the DCM main dialog box
changes to "Running" after the drivers have started.
Important:
In some cases, especially with Internet telephony boards, the drivers can
take several minutes to start. After five minutes, a dialog box may open and indicate that
the drivers have not yet started. Click Continue to continue the startup procedure.
If you encounter a problem, see "Troubleshooting Intel Dialogic board problems" on
page C-1.
When you have verified that the Intel Dialogic drivers start successfully, stop the
drivers. See Appendix D, "Using the Intel Dialogic Configuration Manager" for
instructions.
TDM Bus,
from the list.
ALaw
Programs > Intel(R) Media Exchange Architecture
. The Intel MEA Configuration main dialog box
.
.
I
NSTALLING
double click
.
Bus-0
drop-down list. Select
Value
for all other locations.
I
T
NTEL
ELEPHONY
C
OMPONENTS
Advertisement
Table of Contents
Troubleshooting
