Table of Contents
Advertisement
3. In
Select VBrick
If you select one VBrick, this populates the
multiple VBricks, it does not populate the panel; if you need to configure the VBricks,
you must add them one at a time.)
4. Complete or modify the fields in
enter a User Name and Password and confirm that Password or the configuration will
fail.
5. Click
Submit
VBricks shown on the previous page.
Note The only time you will manually complete the VBrick Configuration fields is when you
are defining the configuration for a VBrick that will be added to the network at a later
time. In this case, you will need to know the following configuration data in advance.
Host Name
IP Address
User Name
User Password
Confirm Password
Software Revision
HTTP Port
VBrick Model
ETV Portal Server Admin Guide
, select one or more existing VBricks for which a SAP has been received.
VBrick Configuration
when done. This adds the new configuration to the list of configured
Required. Host name of VBrick.
Required. IP address of VBrick.
Defaults to system-defined value if blank.
Defaults to system-defined value if blank.
Defaults to system-defined value if blank. Must match User
Password if entered above.
Optional. To get the Software Revision, use IWS (for MPEG
and WM) or VBAdmin (for H.624).
Optional. To get the HTTP Port, use IWS (for MPEG and
WM) or VBAdmin (for H.624).
Select from the dropdown. Advanced settings are enabled if
you select an encoder or a VBStar.
panel. (If you select
VBrick Configuration
as necessary. Note that you must
Global Settings
45
Advertisement
Table of Contents
