Table of Contents
Advertisement
3. On the following window, select
the machine as a warm backup. This will complete the configuration and there is no need
to reboot the server.
4. When finished, launch ETV Backup using the desktop icon.
6. Test the Configuration
When you are finished configuring the IP addresses, click the
footer. All backup profiles should run without errors and a window similar to the one shown
below will report a successful backup for each profile. If problems occur, for example if you
entered an invalid IP address, the window will report any failures. Correct the problems using
the information provided in the log window and try again.
To test the configuration:
1. Highlight the
2. Click
Continue Run
3. If no errors occur, a window similar to the one shown below will be displayed.
164
Enable
MCS Warm Backup Group
for each
Differences for profile: xxxxx
and click
, then
Next
OK
Run
and click
.
Run
window and then
to exit. This will enable
icon in the navigation
.
OK
© 2009 VBrick Systems, Inc.
Advertisement
Table of Contents
