Table of Contents
Advertisement
2. Click on
Specify LAN Address Range(s)
Internal users are identified by this range. Note: the VBrick encoder IP Address must be
in this range.
Portal Server User Configuration
If authentication is enabled on the Portal Server, users must be authenticated and given Live
Channel Privileges. See the Portal Server Admin Guide for more information.
Portal Server Scheduler Configuration
A live broadcast can only be initiated using the Portal Server Scheduler component. A stream
will be pushed to the configured destination, from your VBrick appliance, at the configured
date and time. You will also need to enable
To push the stream via the scheduler
1. Launch the Scheduler and go to Schedule:
2. For
Video Source
3. Highlight your WM VBrick network appliance in the list of VBrick Host Names.
4. If the local LAN is multicast-enabled select a multicast destination, otherwise select
unicast destination.
5. Go to
Advanced Settings
6. If you wish to allow access to remote Portal Server clients, Enable the
otherwise leave this disabled.
7. Schedule End options should be left as
Figure 25. Portal Server Scheduler Page – Advanced Options
202
and enter the address range of your local LAN.
Ext. SAP
select
.
VBrick
and enable
HTTP Push
Disabled
and
as explained below.
HTTP Push
Live Broadcast
.
.
© 2009 VBrick Systems, Inc.
,
EXT SAP
Advertisement
Table of Contents
