Table of Contents
Advertisement
Configuring ETV Backup
To configure EtherneTV Backup, you must perform all of the following steps in the
exact sequence shown
1. Enter License Key.
2. Set Profile IP Addresses.
3. Configure the Scheduler.
4. Reset Database Backup Versioning.
5. Enable the Warm Backup Server.
6. Test the Configuration.
1. Enter License Key
The first time you launch ETV Backup, you will be prompted for a license key. This key is
attached to the "Software Activation Keys" card shipped with the EtherneTV server.
To enter the license key:
1. Find your license key on the "Software Activation Keys" card, type it into Notepad, and
copy it to the clipboard (Ctrl-C).
2. Launch ETV Backup: go to
3. When the Serial Number window is displayed, paste the license key into the window
(Ctrl-V) and the ETV Backup application will automatically be launched.
2. Set Profile IP Addresses
ETV Backup is shipped with a preconfigured profile "group" called
This group has individual profiles corresponding to all of the key Portal Server directories
that need to be backed up. All ETV Backup functions use this preconfigured group. Before
you can run ETV Backup you need to set the IP addresses for each of the individual profiles
in
MCS Warm Backup Group
your live Portal Server.
To set the profile IP addresses:
1. Double-click on the first profile (or right-click and select
MCS Database Backup
Preferences > Double-click Action
ETV Portal Server Admin Guide
Start > All Programs > VBrick > ETV Backup
. These addresses must correspond to the actual IP address of
. (This should open the following window. If not check that
is set to
Modify the profile
EtherneTV Backup
.
MCS Warm Backup Group
) in the group which is
Modify
.)
.
161
Advertisement
Table of Contents
