Table of Contents
Advertisement
WM Publishing
Points
Adding Publishing Points to a VOD-WM Server
In a typical scenario, first you configure the publishing point on the Windows Media server,
then you configure the publishing point on the Portal Server with matching values. Additional
publishing points are required to make content available when you add disk space to a
Windows Media server. As shown on the previous window, a Windows Media Server
supports multiple publishing points. In this context, publishing points are used to discover your
content via FTP. Use the following steps, in the order shown, to create a new publishing
point. Note that as explained below, you must create a virtual FTP directory in IIS for each
publishing point on the WM Server.
To add a publishing point:
1. Create an FTP server on the WM server. See Creating a VOD-WM FTP Server on
page 38.
2. Create a publishing point on the WM Server.
a.
Go to
Start > Administrative Tools > Windows Media Services
b. Right-click on the server_name and select
c.
Add a meaningful publishing point name and click Next.
d. Select
Files (digital media or playlists) in a directory
e.
Select
On-demand publishing point
f.
Specify the location of your content, for example
g.
Skip through the remaining steps and click
3. To create a virtual directory on the WM server for this publishing point:
a.
Go to
Start > Administrative Tools > Internet Information Services (IIS) Manager
b. Navigate to the Default FTP Website. Right-click and select
c.
For
Alias
d. Enter the path to the content directory for this FTP site and click Next.
36
Name
The publishing point on the VOD-WM (default = VBP)
server where content will be accessed and managed by the
ETV Portal Server. Note: this setting must correspond to an
existing , valid publishing point on the server.
Source
Local path to the publishing point. Default =
. Do not change for first publishing point.
WMRoot
FTP
Path to user-created FTP directory. See Creating a VOD-WM
Directory
FTP Server.
Low Space
Optional. Default = 20 MB. If the available disk space on this
Threshold
publishing point is less than the specified value, the
publishing point with the largest amount of free space will be
used.
Free Space Optional. This option automatically calculates the free space
(in GB) available on disk when you add a new publishing
point or refresh the publishing point list. This feature can
consume server resources and is disabled by default. To
enable (or disable) this option (on VOD-WM servers or File
Servers), go to
run
EnableQueryDiskSpace.reg
respectively, and reboot the server when done.
, use the Publishing Point name from Step 3 above and click Next.
<install_dir>\program files\VBrick\MCS\utils
or
DisableQueryDiskSpace.reg
Add Publishing Point (Wizard)
and click Next.
and click Next.
d:\WMPub\WMRoot
when done.
Finish
d:/wmpub/
,
.
.
and click Next.
.
.
New > Virtual Directory
© 2009 VBrick Systems, Inc.
Advertisement
Table of Contents
