HP StorageWorks P9000 User Manual page 86

4. For Copy Pace, specify the pace for initial copy activity per volume. This field cannot be
specified on the remote system. Low is the default. When specifying Medium, insure that write
I/O is 10 MB/s or less per parity group. If it exceeds 10 MB/s, pairs may be suspended.
When specifying High, insure that I/O will not occur. If update I/O occurs, pairs may be
suspended.
5. For Unit of Path Watch Time, specify the unit of time for Path Watch Time, minute, hour, or
day.
6. For Path Watch Time, specify the interval from the time a path becomes blocked to when the
mirror is split (suspended). The interval must be the same for master and restore journals in
the same mirror (see next item).
NOTE:
Technical Support to set system option mode 448 to ON and set system option mode 449 to
OFF.
7. For Forward Path Watch Time, specify whether to forward the Path Watch Time value of the
master journal to the restore journal. If the Path Watch Time value is forwarded from the master
journal to the restore journal, the two journals will have the same Path Watch Time value.
- Yes: The Path Watch Time value will be forwarded to the restore journal.
- No: The Path Watch Time value will not be forwarded to the restore journal. No is the default.
- Blank: The current setting of Forward Path Watch Time will remain unchanged.
CAUTION:
the delta resync configuration, select Yes in the primary storage system.
8. For Transfer Speed, specify the line speed (in Mbps (megabits per second)) of data transfer.
Specify one of the following: 256, 100, or 10. Recommended values are as follows:
- 10 is recommended if the transfer speed is from 10 Mbps to 99 Mbps.
- 00 is recommended if the transfer speed is from 100 Mbps to 255 Mbps.
- 256 is recommended if the transfer speed is 256 Mbps and more.
86 Maintaining the system
If you want a mirror to split immediately after a path becomes blocked, ask HP
This option cannot be specified in the secondary storage system. For a pair using