Replacing The Failed Component; Replacement Instructions - HP EVA P6000 User Manual

Replacing the failed component

CAUTION:
protection.
Always transport and store CRUs in an ESD protective enclosure.
Do not remove the CRU from the ESD protective enclosure until you are ready to install it.
Always use ESD precautions, such as a wrist strap, heel straps on conductive flooring, and
an ESD protective smock when handling ESD sensitive equipment.
Avoid touching the CRU connector pins, leads, or circuitry.
Do not place ESD generating material such as paper or non anti-static (pink) plastic in an ESD
protective enclosure with ESD sensitive equipment.
HP recommends waiting until periods of low storage system activity to replace a component.
When replacing components at the rear of the rack, cabling may obstruct access to the
component. Carefully move any cables out of the way to avoid loosening any connections.
In particular, avoid cable damage that may be caused by:
Kinking or bending.
◦
◦ Disconnecting cables without capping. If uncapped, cable performance may be impaired
by contact with dust, metal or other surfaces.
◦ Placing removed cables on the floor or other surfaces, where they may be walked on or
otherwise compressed.

Replacement instructions

Printed instructions are shipped with the replacement part. Instructions for all replaceable components
are also included on the documentation CD that ships with the P6300/P6500 EVA and posted
on the web. For the latest information, HP recommends that you obtain the instructions from the
web.
Go to the following web site: http://www.hp.com/support/manuals. Under Storage, select Disk
Storage Systems, then select HP P6300/P6500 Enterprise Virtual Array Systems under P6000/EVA
Disk Arrays. The manuals page for the P6300/P6500 EVA appears. Scroll to the Service and
maintenance information section where the following replacement instructions are posted:
HP P6300/P6500 EVA FC Controller Enclosure Replacement Instructions
HP P6300/P6500 EVA FC-iSCSI Controller Enclosure Replacement Instructions
HP Controller Enclosure Battery Replacement Instructions
HP Controller Enclosure Cache DIMM Replacement Instructions
HP Controller Enclosure Fan Module Replacement Instructions
HP Controller Enclosure LED Display Replacement Instructions
HP Controller Enclosure Management Module Replacement Instructions
HP Controller Enclosure Midplane Replacement Instructions
HP Controller Enclosure Power Supply Replacement Instructions
HP Controller Enclosure Riser Assembly Replacement Instructions
HP Large Form Factor Disk Enclosure Backplane Replacement Instructions
HP Small Form Factor Disk Enclosure Backplane Replacement Instructions
HP Disk Enclosure Fan Module Replacement Instructions
76 Replacing array components
Components can be damaged by electrostatic discharge (ESD). Use proper anti-static