Issues And Solutions; Issue: Hp P6000 Command View Does Not Discover The Iscsi Or Iscsi/Fcoe Modules; Issue: Initiator Cannot Login To Iscsi Or Iscsi/Fcoe Module Target - HP EVA P6000 User Manual

Figure 75 iSCSI and iSCSI/FCoE module properties

Issues and solutions

Issue: HP P6000 Command View does not discover the iSCSI or iSCSI/FCoE modules

Solution 1: Ensure that a DHCP server is available.
Solution 2: Set a static IP address on each iSCSI and iSCSI/FCoE module through the CLI.
Solution 3: Ensure the HP P6000 Command View station is on the same subnet of the management
ports.
Solution 4: Enter the known IP address of the management port of the iSCSI modules in the HP
P6000 Command View discovery screen.

Issue: Initiator cannot login to iSCSI or iSCSI/FCoE module target

Solution 1: Ensure the correct iSCSI port IP address is used
Solution 2: In HP P6000 Command View, , for each iSCSI controller 01 and 02, click the IP ports
tab, then expand the TCP properties under the Advanced Settings. There should be available
connections; if not, choose another IP port to log in to or reduce the connections from other initiators
by logging out from unused connections (see
158 Troubleshooting
Figure 76 (page 159)).