7.
Push back the paper set levers to clamp the paper against the
guide rollers.
8.
Before printing, make sure the paper release lever is set to the
single-sheet position. Also set the paper thickness lever to the
correct position for the paper loaded in the cut-sheet feeder,
as described on page 3-6.
9.
In your printer driver software, select your paper size from the
Paper Size list, and select Sheet Feeder Bin-1 from the Paper
Source list. (If you are printing from a DOS application, select
the bin number using the Tear Off/Bin button on the control
panel.)
The cut-sheet feeder loads paper when you send data to the
printer. You can also load paper by pressing the Load/Eject
button.
5-10
Using Printer Options