Brother RH-981A Instruction Manual page 9

(9) [SHORT CUT] key (16 keys)
・ [Sewing speed] key
Pressing this key will show the setting screen for the sewing speed of the machine.
・ [Eyelet pattern] key
Pressing this key will show the setting screen for the eyelet pattern.
・ [Button hole length] key
Pressing this key will show the setting screen for the button hole length.
・ [Taper length] key
Pressing this key will show the setting screen for the taper length.
* When a machine with the straight bar tack specifications is connected, the setting
screen for the straight bar tack length will be displayed.
・ [Offset] key
Pressing this key will show the setting screen for the offset of the taper bar.
* When a machine with the straight bar tack specifications is connected, the setting
screen for the straight bar tack needle number will be displayed.
・ [Stitch pitch] key
Pressing this key will show the setting screen for the stitch pitch in straight section.
・ [No. of eyelet stitches] key
Pressing this key will show the setting screen for the number of eyelet stitches.
・ [Cutting space] key
Pressing this key will show the setting screen for the cutting space.
・ [Knife X position compensation] key
Pressing this key will show the setting screen for the compensation of knife X positions.
・ [Knife Y position compensation] key
Pressing this key will show the setting screen for the compensation of knife Y positions.
・ [Start tying stitches] key
Pressing this key will show the setting screen for the number of start tying stitches.
・ [End tying stitches] key
Pressing this key will show the setting screen for the number of end tying stitches.
・ [X alignment] key
Pressing this key will show the setting screen for the X alignment.
・ [Y alignment] key
Pressing this key will show the setting screen for the Y alignment.
・ [θ1 alignment] key
Pressing this key will show the setting screen for the alignment of θ1.
・ [θ2 alignment] key
Pressing this key will show the setting screen for the alignment of θ2.
(10) [ ] key
The key is used to select icons and move the cursor.
PD-9810
Chapter 1 INTRODUCTION
E-3