Brother RH-981A Instruction Manual page 21

Operations from 6 to 7 are for changing the numerals of parameter 01 (eyelet pattern) from [2]
to [4].
6. Select parameter 01 (eyelet pattern) by either one of three methods described below:
A. Press the [Eyelet pattern] key.
B. Move the cursor to the icon of parameter 01 with the [
C. Move the cursor to [NO.] with the [
[ENTER] key.
7. Change the numeral to [4] with the [+/-] key and press the [ENTER] key.
When you want to cancel the changed numeral, press the [ESC] key. The changed numeral is cancelled
and the screen returns to the previous one.
Operations from 8 to 9 are for changing the numerals of parameter 02 (button hole length)
from [30] to [28].
8. Select parameter 02 (button hole length) by either one of three methods described below:
A. Press the [Button hole length] key.
B. Move the cursor to the icon of parameter 02 with the [
C. Move the cursor to [NO.] with the [
[ENTER] key.
9. Change the numeral with the [+/-] key and press the [ENTER] key.
When you want to cancel the changed numeral, press the [ESC] key. The changed numeral is cancelled
and the screen returns to the previous one.
(NOTE) The work clamp data of the sewing machine will be shown in the lower part of the screen.
Numbers outside the range can be set here, but it will cause an error when writing them to the
machine.
Chapter 3 EXAMPLE OF THE PROGRAM CHANGE PROCEDURE
] key and select No. 01 with the [+/-] key. Then, press the
W0041Q
W0106Q
] key and select No. 02 with the [+/-] key. Then, press the
W0044Q
W0108Q
PD-9810
] key and press the [ENTER] key.
] key and press the [ENTER] key.
W0107Q
W0109Q
E-15