Brother RH-981A Instruction Manual page 22

Chapter 3 EXAMPLE OF THE PROGRAM CHANGE PROCEDURE
Operations from 10 to 11 are for changing the numerals of parameter 19 (taper tack angle)
from [0] to [1]
10. Select parameter 19 (taper tack angle) by either one of two methods described below:
A. Move the cursor to the icon of parameter 19 with the [
B. Move the cursor to [NO.] with [
Then, press the [ENTER] key.
11. Change the numeral with the [+/-] key and press the [ENTER] key.
When you want to cancel the changed numeral, press the [ESC] key. The changed numeral is cancelled
and the screen returns to the previous one.
Operations from 12 to 15 are for writing the changed data to the machine.
12. When the auto read/write setting is ON, press [P] key to end the programmer.
Then the parameter for the program No., which is under edition, is automatically written to the
machine.
With above operational steps finished, parameter change and program writing have been completed.
When the auto read/write setting is OFF, press the [MENU] key to display the menu screen.
13. Select the <Machine write> icon and press the [ENTER] key.
14. Confirm program No. 5 is set and select [YES] with the [
15. The buzzer starts to sound and press the [P] key to end the programmer after the writing is
completed.
Parameter change and writing of the program have completed after going through operations 1 - 15.
E-16
] key and select No. 19 with the [+/-] key.
W0047Q
W0110Q
W0012Q
W0014Q
] key. Then, press the [ENTER] key.
1584Q
PD-9810
] key and press the [ENTER] key.
W0111Q