Program Reading From The Machine - Brother RH-981A Instruction Manual

Chapter 5 PROGRAM READING AND WRITING

Program Reading from the Machine

1. Press the [P] key to start the programmer.
When the auto read/write setting is set to OFF, the menu screen appears and so does the parameter
setting screen when set to ON. For further details, refer to "Auto Read/Write Setting"(page E-34).
2. Select the <Machine read> icon with [
When the auto read/write setting is set to ON, the screen below does not appear. For further details,
refer to "Auto Read/Write Setting"(page E-34).
3. Press the [ENTER] key after confirming the program No..
The data is read from the machine.
4. Press the [ENTER] key.
The screen below appears.
(NOTE) The screen shown is an example when the programmer is connected to the machine with
the taper tack specifications. When the programmer is connected to the machine with the
straight bar tack specifications, a partly different screen will be displayed.
E-28
W0012Q
] key and press the [ENTER] key.
W0013Q
1577Q
W0040Q
W0034Q
PD-9810