Parameter Changing Of The Program - Brother RH-981A Instruction Manual

Chapter 3 EXAMPLE OF THE PROGRAM CHANGE PROCEDURE
Parameter Changing of the Program No. 5
Described below is a series of operations for parameter changing.
Procedures below exemplify how to change settings as follows by reading program No. 5 and how to
write the changed data to the machine.
• Changing the numerals of parameter 01 (eyelet pattern) from [2] to [4].
• Changing the numerals of parameter 02 (button hole length) from [30] to [28].
• Changing the numerals of parameter 19 (taper tack angle) from [0] to [1].
At first, read program No. [05] from the machine.
1. Set program No. of the machine to [05] and press the [P] key.
The program No.5 is automatically read. Then proceed to step 6. When the auto read/write setting is
OFF, continue to perform step 2 through step 5. At the time of shipping, the auto read/write setting is
set to be ON.
2. Press the [MENU] key to display the menu screen.
3. Select the <Machine read> icon and press the [ENTER] key.
4. Select [YES] with the [
The data is read from the machine.
5. Confirm PGNO. is set to 05 and press the [ENTER] key.
(NOTE) The parameter screen can also be displayed with the [SHORT CUT] key.
E-14
W0013Q
] key and press the [ENTER] key.
1577Q
W0040Q
PD-9810