Connecting A Dvd Player With Component Video Connectors - Sony KLV-15SR1 Operating Instructions Manual

Ir_stNE ng and Cor_r_ec_ingthe IV
Connecting a DVD Player with Component Video
Connectors
This is the preferred hookup to use if:
• Your DVD player has component (Y, B-Y, R-Y) jacks.
Disconnect all power sources before making any connections.
1
Using three separate component video cables, connect the DVD player's
Y, B-Y and R-Y jacks to the Y, P_3and PR jacks on the TV. Use the
VIDEO 2 IN connections.
Note
This TV supports only the 480i signal format, if the TV receives a signal other than 480i,
"Non Supported Video Format" appears on the screen.
Tip
The Y, B-Y and R*Y jacks on your DVD player are sometimes labeled as Y, C_ and C_,
or Y, P_ and PR. If so, connect the cables to the matching colors.
2 Using an AUDIO cable, connect the DVD player's AUDIO OUT jacks to
the TV's AUDIO IN jacks.
Note
The Y, B-Y and R*Y jacks do not provide audio, so audio cables must be connected to
provide sound.
Rear of TV
Tips
• To take advantage of the Wide Screen Modes, set the TV's aspect ratio to 16:9 on your
DVD player. For details, refer to the operating instructions supplied with your DVD player.
• Some DVD players are equipped with the three component video connectors: Y-Green, P_
(C_, Cu or B-Y) *Blue and PR (G_, C_ or R-Y) -Red.
16