Unpacking; Inserting Batteries Into The Remote; Control - Sony KLV-15SR1 Operating Instructions Manual

Hide thumbs Also See for KLV-15SR1:
Table of Contents

Advertisement

Unpacking
When you unpack this unit, make sure it includes the
following:
Remote control (1) and
size AA batteries (2)
AC power cord (1)
75-ohm coaxial cable (1)
AC poweradaptor(1)
Operating Instructions
Warranty Card
Supplied
75-ohm
coaxial
cable
Screw-on type
Screw into connection,
S VIDEO cable
High quality video cable for enhanced
picture quality
Align guides and push into
connection.
AUDIONIDEO
cable
Push into connection.
VIDEO - Yellow
AUDIO (Left) - White
AUDIO (Right) - Red
Some DVD players are equipped with the following
three video connectors:
Y - Green
PB(CB, Cb or B-Y) - Blue
PR(C_, C, or R-Y) - Red
Inserting Batteries into
the Remote Control
Insert two size AA batteries
(supplied)
by matching
the + and - on the batteries
to the diagram
inside the
remote control's
battery compartment.
Notes
• Remove the batteries to avoid damage from possible battery
leakage whenever you anticipate that the remote control will
not be used for an extended period.
• Handle the remote control with care. Avoid dropping it,
getting it wet, or placing it in direct sunlight, near a heater or
where the humidity is high.
• Your remote control can be programmed to operate most video
equipment (See "Operating Video Equipment with Your TV
Remote Control" on page 28).
7

Advertisement

Table of Contents
loading

Table of Contents