Connecting A Dvd Player With Component Video Connectors - Sony KLV-23HR1 Operating Instructions Manual

Ir_stNE ng and Cor_r_eo_ingthe IV
Connecting a DVD Player with Component Video
Connectors
This is the preferred hookup to use if:
• Your DVD player has component (Y, B-Y, R-Y) jacks.
Disconnect all power sources before making any connections.
1 Using three separate component video cables, connect the DVD player's
Y, B-Y and R-Y jacks to the Y, PB and P_ jacks on the TV. Use the
VIDEO 3 1N connections.
Tip
The Y, B*Y and R-Y jacks on your DVD player are sometimes labeled as Y, C_ and C_,
or Y, P_ and P_. if so, connect the cables to the matching colors.
2 Using an AUDIO cable, connect the DVD player's AUD10 OUT jacks to
the TV's AUD10 IN jacks.
Note
The Y, B*Y and R-Y jacks do not provide audio, so audio cables must be connected to
provide sound.
Rear of TV
VMC-IOHG
(not supplied)
Tips
• To take advantage of the Wide Screen Modes, set the TV's aspect ratio to 16:9 on your
DVD player. For details, refer to the operating instructions supplied with your DVD player.
• Some DVD players are equipped with the three component video connectors: Y - Green, P_
(Cf_, Cb or B-Y) - Blue and P_ (CR, C_ or R-Y) - Red.
16