Basic Connections; An Antenna); Removing The Rear Cover; Connecting Directly To Cable - Sony KLV-15SR1 Operating Instructions Manual

Basic Connections
(Connecting Cable TV or
an Antenna)
When connecting an antenna or cables, remove the
rear cover of the TV beforehand.
Removing the rear cover
1
Slide the rear cover upward by approx. 1 cm
(13/32
inch) while holding it with both hands as
shown in the diagram below.
2
Pull the rear cover towards you.
l!
Attaching the rear cover
1
Hold the rear cover with both hands, then fit the
four detents on the rear cover into the
corresponding keyholes on the TV while keeping
the rear cover approx. 1 cm (_3/32inch) higher
than the TV as shown in the diagram below.
2 Slide the rear cover downward while keeping it
pressed against the TV.
hr_s_a_i hg and Cow_w_ec_ing _heIV
Connecting directly to cable or an
antenna
VHF only or VHF/UHF or cable
75-ohm coaxial
Rear of TV
cable (supplied) _'_
VHF/UHF
Note
It is strongly recommended to connect the antenna using a 75-
ohm coaxial cable to get optimum picture quality. A 300-ohm
twin lead cable can be easily affected by radio noise and the like,
resulting in signal deterioration, if you use a 300-ohm twin lead
cable, keep it away as far as possible from the TV.
Cable box connections
Use this hookup if:
• You subscribe to a cable TV system that uses
scrambled or encoded signals requiring a cable
box to view all channels, and
• You do not intend to hook up any other audio or
video equipment to your TV.
1 Connect the coaxial connector from your cable
service to the cable box's IN jack.
2 Using the supplied 75-ohm coaxial cable,
connect the cable box's OUT jack to the TV's
VHF/UHF jack.
75-ohm coaxial
Cable cable (supplied)
_;_LE_ ,_ Rear of TV
,1
IN _ OUT
Cable box
Also, set "Cable" to "On" in the _ (Channel)
menu (See page 20).
Tips
• Your Sony remote control can be programmed to operate your
cable box (See "Programming the remote control" on page
28).
• To change channels using the cable box, set your TV to
channel 3 or 4 depending on the cable box channel output.
• if you will be controlling all channel selection through your
cable box, consider using the Channel Fix feature to set your
TV to channel 3 or 4 (See page 21).
9