Setting The Ir Channel - Gefen EXT-DPKVM-841 User Manual

In the event that IR commands from other remote controls interfere with the
supplied IR Remote Control unit, changing the IR Remote Control's IR channel
will fi x the problem. The IR Remote Control unit has a bank of DIP switches used
for setting the IR channel. The DIP switch bank is located underneath the battery
cover.
Corresponding DIP Switch Settings for each IR Channel
IR Channel 0
(default)
ON
1 2
It is important that the IR channel on the Remote Control unit, matches the IR
channel set on the 8x1 DPKVM Switcher. For example, if both DIP switches on
the IR Remote Control unit are set to IR channel 0 (both DIP switches down),
then the 8x1 DPKVM Switcher must also be set to IR channel 0. See page 21 on
how to change the IR channel on the 8x1 DPKVM Switcher.
IR REMOTE CONTROL UNIT

Setting the IR Channel

IR Channel 1
ON
1 1 2 2
10
Left: Picture of the
opened rear battery
compartment of the IR
remote showing the
exposed DIP Switch
bank between the battery
chambers.
IR Channel 2
ON
1 2
IR Channel 3
ON
1 2