Installing The Operation Panel; Routing The Connector Cord And Installing The Oil Stopper Plate - Brother HE-800A Instruction Manual

４-９. Installing the operation panel
Top of work table
Bottom of work table
４-１０. Routing the connector cord and installing the oil stopper plate
3863Q
The operation panel can be installed to either the top
or bottom of the work table.
1. Install the rear frame (1) to the work table (top or
bottom) with the four wood screws (2).
2. Install the front frame assembly (3) to the rear frame
(1) with the four screws (4).
* The vertical orientation of the front frame assembly
(3) is the same whether it is installed to the top or
the bottom of the work table.
* Pull the harnesses such as the ground harness out
Table
of the way so that the operation panel side cover
(5) can be opened and closed.
3. Insert the connector cord (6) into the control box
through the hole at the side of the box.
Table
3864Q
3865Q
1. Gently tilt back the machine head.
2. Pass the cords (1) through the hole in the work
table.
3. Install the oil stopper plate (2).
4. Move the connector cord (1) so that it will not be
clamped by the machine head and the bed base (3),
and then return the machine head to its original
position.
3866Q
HE-800A
4. INSTALLATION
12