Recharging The Battery - Canon EOS-1DS Mark III Instruction Manual

Recharging the Battery
I
Connect the charger to a power outlet.
® Connect the power plug to a power outlet,
and connect the power cord to the charger.
® When no battery is attached, all the
indicator lamps will be off.
_ Remove the protective covers
from the charger and battery.
® Remove the protective cover on the
charger by sliding it out.
_ Recharge the battery.
® Slide in the battery into the charger's
slot as shown by the arrow, and make
sure it is securely attached. You can
attach the battery to slot A or B.
_y,, T he Charge level indicator will light in
green and charging will start.
_y,, W henthebatteryisfullycharged, a ll threeCharge
levelindicators w illlight(50%/80%/100%).
® It takes aboutg hoursto futRyrechargea
completelye×haustedbattery,The time
required to recharge the batterydependsonthe
ambient t emperature andbattery'schargelevel.
I_ _ The charger cannot charge any battery other than Battery Pack LP-E4
_* BatteryPack LP-E4is dedicatedto Canononly,using it with a non-Canonbatterycharger
3r productmay resultin malfunction)r acc_aents for which Canoncannotbe held Itabte.
For battery calibration (p,28), it is best to do tatter the battery is nearly exhausted.
If you do the calibration with a full} charged battery, [t will take about !2 hours to
complete the ca_ora[ion _uoweralscnarge) ann the battery recharging {approx. 10
nours to discharge, and approx. 2 hours to fully recnarge_.
When two battery p acks a reattached tothecharger, thebattery attached first w illbecharged f irst,
then theomer b attery t _,eecharged. Although onebatten/can eerecnargea and another
sa!_erarea
p.2_atthesame time. t wobattenes cannot be
techar_
_.d orcalibrated atthesame time.
26