Connecting The Sensor Pen; Using The Sensor Pen Holder - Brother BP2100 Operation Manual

CONNECTING THE SENSOR PEN

When connecting the sensor pen to the machine, make sure that the arrow on the sensor pen connector
faces up, lines up with the arrow on the machine, and that the connector is firmly inserted into the jack.
a Sensor pen jack
b Sensor pen connector
CAUTION
• When connecting the sensor pen, make sure
that the arrow on the sensor pen connector
faces up and aligns with the arrow on the
machine, otherwise the connector pins will
not align correctly and the connector will be
damaged.
• When connecting or disconnecting the sensor
pen, grab the connector, and then slowly push
it straight in or pull it straight out.
• When disconnecting the sensor pen from the
machine, do not pull on the cord, otherwise
the sensor pen may be damaged.

Using the Sensor Pen Holder

When connecting the sensor pen to the machine,
attach the sensor pen holder to keep the sensor
pen with the machine.
The right side of the holder can be used to hold the
touch pen.
Sensor pen holder

CONNECTING THE SENSOR PEN

a
Using the point end of the cleaning brush or
the seam ripper point, remove the
protective cap covering the hole on the
right side of the machine.
→ Insert the point of the seam ripper or cleaning brush
into the hole in the protective cap, and then lightly
pull out the protective cap to remove it.
b
Firmly insert the sensor pen holder into the
hole where the protective cap was
removed.
Basic operations B-53
B
2