Blade Tilt Or Squareness Of Blade To Table - Craftsman 113.24250 Owner's Manual

If tooth does not touch Front and Rear... the mechanism
underneath must be adjusted to make the blade
PARALLEL to GROOVE.
NOTE: Make sure TI LT CLAMP KNOB is tightened.
1. Lay the saw on its LEFTSIDE.
2. Loosen He×. Head screw "A" between 1/4 and 1/2
turn, using a 5/8 in, socket wrench with an extension.
3. Tilt blade to 45 ° and loosen screw "B".
4. Place saw in upright position.., tilt blade to 90 °.
5. Remove blade.., lower the motor all the way down.
6. Reach inside of the insert opening and loosen screws
"C" and "D" 1/4 to 1/2 turn, using a 5/8 in. wrench.
7. Replace sawblade and raise it all the way up.
8. Grasp spreader bar at rear of saw and move sideways
•.. recheck blade alignment with square.
9. When blade is PARALLEL to groove.., tighten screws
"C" and "D".
10. Lay saw on its LEFT SIDE and tighten screws "A" and
"B",
SCREW "C
l
i
!
\
"o"
\\\
jj
BLADE TI LT, OR SQUARENESS
OF BLADE TO TABLE
90 ° (SQUARE)and 45 ° (BEVEL) STOP COLLARS.
When the bevel pointer is pointing directly to the "O" mark
on the bevel scale, the sawblade should make a SQUARE
cut 90 ° to the table.
To check for SQUARENESS:
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH
"OFF" AND REMOVE PLUG FROM POWER SOURCE
OUTLET.
1. Raise blade all the way UP ... raise blade guard.
2. TILT blade a few degrees to the LEFT ... nowtilt
blade back to the RIGHT as far as it will go.
3. Place ACCURATE square against blade. Make sure
square is not touching the TIP of one of the saw
TEETH.
24