Installable Racks; Fujitsu Racks; Non-Fujitsu Racks - Fujitsu ETERNUS DX60 S2 User Manual

Chapter 4 Rack and Optional Product Installation

4.2 Installable Racks

4.2 Installable Racks
This section explains the racks in which the ETERNUS DX Disk storage system can be installed.
4.2.1

Fujitsu Racks

The ETERNUS DX Disk storage system can be installed in a Fujitsu 19-inch rack. For informa-
tion about whether the ETERNUS DX Disk storage system can be installed in an EOLed rack or
not, contact your sales representative.
4.2.2

Non-Fujitsu Racks

ETERNUS DX Disk storage systems are developed and their operation is guaranteed on the
assumption that they are installed in Fujitsu 19-inch racks. Since the ETERNUS DX Disk storage
system cannot be tested (for cooling and strength) in non-Fujitsu 19-inch racks, the operations of
ETERNUS DX Disk storage systems cannot be guaranteed. Any problem that may occur by
installing the ETERNUS DX Disk storage system in non-Fujitsu racks is not covered by the war-
ranty.
If the ETERNUS DX Disk storage system needs to be installed in a non-Fujitsu rack, the follow-
ing conditions must be satisfied.
■
Rack specifications
Use the rack mount kit supplied with the product to install the ETERNUS DX Disk storage system
in the rack. The rack specifications must satisfy the conditions listed below. For rack specifica-
tions, refer to the manual that is supplied with the rack that is used.
• Pitch for mounting holes
EIA Standard Universal pitch
• Size for mounting holes
The size must be 9mm or more.
• Load bearing capacity
The load bearing capacity must be equal to or larger than the total weight of the ETERNUS
DX Disk storage system.
• Unit installation area
The dimensions of the area shown in
4.2.
ETERNUS DX60 S2 Disk storage system User's Guide -Site Planning-
Figure 4.1
54
Copyright 2012 FUJITSU LIMITED
must match the conditions described in Table
P3AM-5492-04ENZ0