Expansion Cards Supported By Serverstart; Cautions For Manual Installation - Fujitsu PRIMERGY RX200 S2 User Manual

Chapter 2 Checking before OS Installation

2.3.5 Expansion Cards Supported by ServerStart

ServerStart supports automatic driver installation for the following expansion cards.
Onboard FDD/IDE
Onboard SCSI
Onboard LAN
Onboard VGA
RAID Ctrl 2-Channel 128 MB w/ BBU
Fibre Channel Controller
LAN cards
SCSI Ctrl U160 lp

2.3.6 Cautions for Manual Installation

■ Cautions for Configuring a Disk Array with an Onboard SCSI Array
Controller
Disk array configuration on the onboard SCSI array controller must be completed before the OS is
installed. To check the onboard SCSI array controller configuration, start up the SCSI Setup Utility. For
more details, refer to "8.3 SCSI Setup Utility" ( pg.233).
If a disk array is not configured on the onboard SCSI array controller, the normal SCSI configuration is
established.
■ Free Space Required for Installation
The partition where the OS is installed must have enough free space for obtaining memory dump. For
more details, refer to "5.1 Memory Dump/Paging File Setting" ( pg.128).
■ Cautions on Restarting
In the course of installation, a message appears to indicate that the setup program restarts. Wait until it
restarts.
For more details on background operations, refer to "PRIMERGY RX200 S2 Onboard SCSI RAID
User's Guide".
48
table: Automatic Expansion Card Driver Installation
Name Model
-
-
-
-
PG-142E3
PG-FC106
PG-1852
PG-1862
PG-1882L
PG-1892L
PG-130L
Bus
-
PCI
PCI
PCI
PCI
PCI
PCI
PCI
PCI
PCI
PCI