Operation After Baseboard Replacement; Rebuild Operation By Automatic Recovery Of Hdd; Notes On Use Of Domain Controller Function - Fujitsu PRIMERGY RX200 S2 User Manual

9.10.2 Operation after Baseboard Replacement

If the baseboard is replaced due to an error when the on-board SCSI array controller function is used for
this server, the logical drive of the array controller is initialized again after replacement. This is because
the data integrity information showing whether data was written correctly in the past is stored in the
baseboard. As the information is lost due to replacement, the initialization is automatically executed to
ensure the data integrity. This does not mean hard disk failure.
For behavior of the initialization, see "Onboard SCSI RAID User's Guide 1.4 Rebuilding/Initializing a
Logical Drive".

9.10.3 Rebuild Operation by Automatic Recovery of HDD

When the on-board SCSI array controller function is used for this server, if the retry count against
recoverable hard disk error exceeds the threshold, automatic rebuild function runs to check the entire
disk. While the automatic rebuild function is running, the hard disk failure lamp blinks, and the front
maintenance lamp comes on due to the ServerView function.
A log "A manual rebuild has started on logical drive." remains in Log Information Viewer on GAM.
During automatic rebuild, hard disks can be accessed, but the access performance is affected. The
performance may be lowered up to 54%. After automatic rebuild is completed, the hard disk can be used
in the redundant state. But, the hard disk should be replaced as soon as possible.
If the above symptom (lamp, message on GAM) occurs although hard disk is not replaced, please
contact the maintenance person or system administrator.
* For automatic rebuild events, ServerView notification are not executed. However, if automatic rebuild
fails, ServerView notification is done as hard disk failure.

9.10.4 Notes on Use of Domain Controller Function

In the case of disk array configuration with the on-board SCSI array controller in this server, if it is used
as a domain controller for Windows Server 2003 x64 Editions, Windows Server 2003, or Windows 2000
Server, the following warning message may be logged in the OS event log during startup.
Type: Warning
Source: Disk
Description: The driver detects a valid writing cache of
\Device\Harddisk0\DR0. The data may be damaged.
For this server, the writing cache is always disabled, and never becomes enabled for the RAID logical
drive configured with SCSI array controllers. However, this message indicates that the logical drive
cache configuration is not correctly recognized. Even if this message is logged, the system operation is
not affected, and data is not damaged.
PRIMERGY RX200 S2 User's Guide
9
289