Raid Wizard - Fujitsu PRIMERGY RX200 S2 User Manual

3.1.3 RAID wizard

Configure RAID.
1
Click [RAID Wizard: Setting for the RAID system].
The [RAID Configuration] window appears.
Only array controllers already installed are displayed.
The number of hard disk units connected to the array controller is displayed.
If you open a configuration file that has been created before, displayed settings may differ from
the previously set values. Be sure to check the settings.
When you do not configure RAID, set the configuration mode to "Use existing array" before
exiting the wizard.
2
Set items and click [leave wizard].
The RAID wizard closes.
PRIMERGY RX200 S2 User's Guide
3
59