Fujitsu PRIMERGY RX200 S2 User Manual page 22

Chapter 1 Overview
g System identification LED (ID)
This LED is used for maintenance. When pressing this button, the front and rear system
identification LEDs are lit blue so that the locations of devices being maintained can be
determined.
Also, the [System Identification LED Display] button of ServerView can be used to light them.
h Hard disk access display LED ( )
This LED lights green when data is being written to or read from the hard disk. It also lights
when the server is accessing the CD-ROM.
i Reset switch (RST)
Pressing this switch resets and restarts the system.
j System identification LED button (
When pressing this button, the front and rear system identification LEDs are lit blue so that the
locations of devices being maintained can be determined.
k Power switch ( )
Press this switch to turn the server on.
l Maintenance switch (
This switch is used only by maintenance personnel. Do not touch this.
m Front maintenance LED ( )
When the ServerView is installed, this LED lights in amber during the logical drive initialization/
rebuild of the onboard disk array controller. This indicates a normal operation.
This LED also lights or blinks in amber when an error is detected in the server components. If it
lights or blinks except for drive initialization or rebuild, contact an office listed in the "Contact
Information" of the "Start Guide".
n Power status LED ( )
This LED lights as follows depending on the server power supply status.
LED status
Off
Lights amber
Lights green
22
When the reset switch is pressed, all unsaved data will be lost. Save the data before resetting
the system.
Do not turn the server off when the hard disk access LED is blinking.
Data in the hard disk may be damaged.
)
NMI
table: Power Supply Status
Power not supplied (power off)
In normal mode (standby mode)
In normal mode (operating mode)
)
ID
Power supply status