Raid Properties Submenu - Fujitsu PRIMERGY RX200 S2 User Manual

Chapter 8 Hardware Configuration/Utilities

8.3.7 RAID Properties Submenu

Sets an array configured with the onboard SCSI array controller.
LSI Logic MPT SCSI Setup Utility
RAID Properties
SCSI Device Identifier
ID
0 -
1
2
3
4
5
6
7 1020/1030
8 SDR CEM318
9
10
11
12
13
14
15
Esc=Abort/Exit
Item
Array Disk?
Hot Spare
Status
Size (MB)
242
Version
Array: SCSI ID:
Array Hot Status
DISK? Spare
[No] [No]
[No] [-]
[No] [-]
[No] [-]
[No] [-]
[No] [-]
[No] [-]
[No] [-]
[No] [-]
[No] [-]
[No] [-]
[No] [-]
[No] [-]
[No] [-]
[No] [-]
[No] [-]
ArrowKeys=Select Item
Home/End=Select Item
table: Items on the RAID Properties Submenu
Setting
• Yes (array type/Linux array
type)
• No (other types than array
type/Linux array type)
No (Fixed parameter)
-
-
MPTBIOS-IMx.xx.xx
Size(MB):
Predict Size
Failure (MB)
***MB
-/+=Change[Item]
Enter=Execute<Item>
Contents
Sets whether or not the hard disk unit configures a
disk array.
The server does not support this.
Displays the hard disk status when a disk array is
configured.
• [Primary] or [OK]
Indicates that the hard disk unit is operating
normally.
• Failed
Indicates that the hard disk unit has failed.
• Out of Sync
Indicates that the hard disk unit being rebuilt.
• Missing
Indicates that the hard disk unit is not installed or
recognized.
Indicates the hard disk capacity.