Creating Raid Volumes; Create A Hardware Mirrored Volume - Fujitsu SPARC Enterprise T5440 Server Administration Manual

Related Information
"Creating RAID Volumes" on page 14
■
"Removing Hardware RAID Volumes" on page 21
■

Creating RAID Volumes

This section contains:
"Create a Hardware Mirrored Volume" on page 14
■
"Create a Hardware Mirrored Volume of the Default Boot Device" on page 15
■
"Create a Hardware Striped Volume" on page 17
■
"Configure and Label a Hardware RAID Volume for Use in the Solaris Operating
■
System" on page 18
"Disk Slot Numbers" on page 20
■

▼ Create a Hardware Mirrored Volume

1. Verify which hard drive corresponds with which logical device name and
physical device name, using the raidctl command.
# raidctl
No RAID volumes found.
See
2. Type the following command:
# raidctl -c primary secondary
A message appears asking you to confirm the operation. For example:
# raidctl -c c0t0d0 c0t1d0
Creating RAID volume c0t0d0 will destroy all data on member disks,
proceed
(yes/no)?
14 SPARC Enterprise T5440 Server Administration Guide • July 2009
"Disk Slot Numbers" on page 20to locate the correct disk number.