Fujitsu SPARC Enterprise T5440 Server Administration Manual page 65

ALOM CMT Shell Status and Control Commands
TABLE:
ALOM CMT Command
showenvironment
showpower [–v]
shownetwork [–v]
console
console –f
break –c
break –D
bootmode [normal]
[reset_nvram] [config=
configname][bootscript =
string]
flashupdate –s IPaddr –f
pathname [–v]
Summary
Displays the environmental status of
the host server. This information
includes system temperatures, power
supply status, front panel LED status,
hard disk drive status, fan status,
voltage, and current sensor status.
Displays power metrics for the host
server.
Displays the current network
configuration information. The –v
option shows additional information
about your network, including
information about your DHCP server.
Connects to the host system console.
The –f option forces the console write
lock from one user to another.
Drops the host server from running
the Solaris OS software into OpenBoot
PROM or kmdb depending upon the
mode in which the Solaris software
was booted.
Controls the host server OpenBoot
PROM firmware method of booting.
Downloads and updates system
firmware (both host firmware and
ALOM CMT firmware). For ILOM,
ipaddr must be a TFTP server. If DHCP
is used, ipaddr can be replaced by the
name of the TFTP host.
Comparable ILOM Command
show –o table –level all
/SYS
show /SP/powermgmt
show /SP/network
start /SP/console
No equivalent in ILOM
set /HOST
send_break_action=break
set /HOST
send_break_action=dumpcore
set /HOST/bootmode property=
value
[where property is state,
config, or script]
load –source
tftp://ipaddr/pathname
ALOM-to-ILOM Command Reference 49