Removing And Reinstalling The Cooling Shroud - Lenovo ThinkServer RD530 Hardware Maintenance Manual

2. To reinstall the rack handles, insert the small tab
Then, align the screw hole in the rack handle with the corresponding hole in the chassis and install the
screw to secure the rack handle on each side of the server.
Figure 30. Installing the rack handles

Removing and reinstalling the cooling shroud

The cooling shroud must be removed to allow access to some of the server components. This topic provides
instructions on how to remove and reinstall the cooling shroud.
Attention: Do not open your server or attempt any repair before reading and understanding "Safety information"
on page iii and "Guidelines" on page 61.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Note: Depending on the model, your server might look slightly different from the illustrations in this topic.
Removing the cooling shroud
To remove the cooling shroud, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. If the server is installed in a rack cabinet, remove the server from the rack cabinet and place it on a flat,
clean, and static-protective surface. See the Rack Installation Instructions that comes with the server.
1 on the rack handle into the hole
PS
U
Me
m
CP U
Chapter 6
2
.
Installing, removing, or replacing hardware
in the chassis.
67