Installing Or Replacing A Heat Sink - Lenovo ThinkServer RD530 Hardware Maintenance Manual

2. Press the tab 1 and carefully pull the handle at the same time to slide the hot-swap redundant power
supply out of the chassis.
Note: Do not use too much force. You can first carefully slide the hot-swap redundant power supply a
little bit out to release it from the secured position. Then, completely slide it out of the chassis.
Figure 57. Removing a hot-swap redundant power supply
3. Install a new hot-swap redundant power supply. See "Installing a hot-swap redundant power supply"
on page 95.
4. If you are instructed to return the old hot-swap redundant power supply, follow all packaging instructions
and use any packaging materials that are supplied to you for shipping.

Installing or replacing a heat sink

Attention: Do not open your server or attempt any repair before reading and understanding "Safety information"
on page iii and "Guidelines" on page 61.
This topic provides instructions on how to install or replace a heat sink.
CAUTION:
The heat sink might be very hot. Turn off the server and wait three to five minutes to let the server
cool before removing the server cover.
.
Chapter 6 Installing, removing, or replacing hardware
99