Server Components - Lenovo ThinkServer RD530 Hardware Maintenance Manual

6 USB connectors (4)
Used to attach a USB-compatible device, such as a USB keyboard, mouse, scanner, or printer. If you
have more than six USB devices, you can purchase a USB hub, which you can use to connect additional
USB devices.
7 VGA DB-15 connector
Used to attach a VGA-compatible video device, such as a VGA monitor.
10
Serial port
Used to attach a device that uses a 9-pin serial port.
11 ID LED
When you press the ID button, the ID LEDs on both the front and rear of the server are lit to help you locate
the server among other servers. You also can turn on the ID LEDs using a remote management program
for server presence detection.
ID LED
On
Off

Server components

This topic provides information about major component locations and CRU identification. For more
information about major components, see the related topics in "Locations" on page 13.
To remove the server cover and the cooling shroud and gain access to the inside of the server, see
"Removing the server cover" on page 63 and "Removing and reinstalling the cooling shroud" on page 67.
The chassis configuration varies by model. The following illustrations show the two chassis configurations
based on the supported hard disk drives.
• Server models with 3.5-inch hot-swap hard disk drives
• Server models with 2.5-inch hot-swap hard disk drives
Note: Depending on the model, your server might look slightly different from the illustrations in this topic.
22
ThinkServer RD530 Hardware Maintenance Manual
Color
Blue
The system is identified.
None The ID LED is not in use or the system is not
identified.
Description