Lenovo ThinkServer RD530 Hardware Maintenance Manual page 155

• Route the signal cables
mini-SAS to mini-SAS signal cable, the front panel cable, the front panel USB cable, the diagnostic
module cable, and the SATA signal cable for the optical drive.
• Connect the power cable
backplane and properly route the cable in the chassis.
• Route the backplane power cable
Figure 105. Cable routing
3. If the cooling shroud is removed, reinstall the cooling shroud. See "Removing and reinstalling the
cooling shroud" on page 67.
1 through the left inner side of the chassis. The signal cables include the
2
for the optical drive to the optical drive power connector on the
3 through the right inner side of the chassis.
.
Chapter 6 Installing, removing, or replacing hardware
141