Adding Privacy Zones - Lorex Vantage LH010 ECO BLACKBOX SERIES Instruction Manual

Using the Main Menu
BNC mode is selected, the mouse
cursor appears on the BNC monitor.
To adjust the video margin:
1 Click the Output tab.
2 Click the Margin button.
3 Drag the sliders to the left or right to
adjust the Left, Right, Top, or Bottom
Margin.
4 Click Apply to save your settings and click
OK to confirm.

Adding Privacy Zones

A privacy zone allows you to block out
one portion (16-channel models) or up
to four portions (4/8-channel models) of
each channel with a black square.
ATTENTION: Areas covered by privacy
zones are not visible in recordings.
To configure a privacy zone:
1 Click the Privacy Zone tab.
2 In the Channel drop-down menu, select
the channel you wish to configure.
32
Privacy Zone
3 Configure the following:
• Channel: Select the channel you wish to
configure.
• Privacy Zone: Select Enable to enable
privacy zones or Disable to disable privacy
zones.
• Area Setup: Select the Area1~4
checkboxes to enable up to 4 privacy
zones.
NOTE: 16-channel models support only one
privacy area.
4 Click the Setup button next to Mask Area.
The Privacy Area setup screen opens.
Click and drag to move privacy zones

Click Inside the edge and drag to resize
• Click on a privacy area and drag to change
its location.
• Click on the edge of a privacy area and
drag to resize a privacy area.
• Right-click when you are finished to exit.
5 (Optional) Use the drop-downs next to
Copy to copy privacy areas to another
channel or all channels. Click the Copy
button to copy privacy areas.
6 Click Apply to save your settings.