Setting Ptz Presets; Selecting Ptz Presets; Deleting Ptz Presets; Starting / Stopping Ptz Cruise - Lorex Vantage LH010 ECO BLACKBOX SERIES Instruction Manual

Appendix B: Connecting a PTZ Camera

Setting PTZ Presets

1 Using the PTZ controls, move the camera into position.
2 (Optional) In the Time field, select the number of seconds the camera will remain in that
position during PTZ cruise before going to the next position.
3 Click Set to set the preset. The Total and No. field will automatically increase. The Total field
shows you the total number of created presets, and the No. field shows you the number of the
preset you are currently creating.
Total Number
of presets
Preset number
Time shown
before changing
4 Complete the steps above to create additional presets as needed. Press Save when you are
finished to save all created presets.

Selecting PTZ Presets

1 In the No. field, select the number of the preset you would like to select.
2 Click Go to to go to the preset.

Deleting PTZ Presets

1 In the No. field, select the number of the preset you would like to delete.
2 Click Clear to delete the preset and click Save to save your changes.

Starting / Stopping PTZ Cruise

When PTZ cruise is enabled, the camera will cycle through saved presets. You must set and
save presets to use PTZ cruise.
To start / stop PTZ cruise:
1 Right-click to open the Menu Bar and click the Start Cruise button (
password. The camera will cycle through PTZ presets.
• To stop the PTZ cruise, right-click to open the Menu Bar and click the Stop Cruise button (
Enter the system password.
102
Save Presets
Clear Preset
Go To Preset
Set Preset
). Enter the system
).