Adjusting Menu Transparency; Adjusting The Video Margin; Adding Privacy Zones - Lorex ECO 2 Instruction Manual

restarts. The DVR will restart with the
default resolution of 1024 x 768.
Stop button (
3 When the DVR restarts, click Yes to
confirm the default resolution.
NOTE: If your system resolution is already
in 1024 x 768, pressing and holding
the Stop button will not restart the
system.

Adjusting Menu Transparency

You can increase or decrease the
transparency of the on-screen menus.
To adjust the transparency of
on-screen menus:
1 Click the Output tab.
2 Drag the Transparency slider to adjust
transparency.
3 Click Apply to save your settings.

Adjusting the Video Margin

If you connect your DVR to a BNC
monitor, you can adjust the video
margins.
NOTE: On the 16-channel model, you must
select the BNC output mode to
adjust the margins. Press 0 on the
remote control to switch the output
mode between BNC mode and VGA/
HDMI mode. When BNC mode is
selected, the mouse cursor appears
on the BNC monitor.
To adjust the video margin:
1 Click the Output tab.
2 Click the Margin button.

)
3 Drag the sliders to the left or right to
adjust the Left, Right, Top, or Bottom
Margin.
4 Click Apply to save your settings and click
OK to confirm.

Adding Privacy Zones

A privacy zone allows you to block out
up to 4 portions of each channel with a
black square.
ATTENTION: Areas covered by privacy
zones are not visible in recordings.
To configure a privacy zone:
1 Click the Privacy Zone tab.
2 In the Channel drop-down menu, select
the channel you wish to configure.
Privacy Zone
3 Configure the following:
• Channel: Select the channel you wish to
configure.
Using the Main Menu
35