Alert Messages - Ricoh Aficio MP C3500 Operating Instructions Manual

Troubleshooting When Using the Printer Function

Alert Messages

This section describes the machine Alert messages.
Message
Cannot connect with
the wireless card.
Turn the main power
switch off, then
check the card.
/
Problems with the
wireless card.
/
Problems with the
wireless board.
4
Problems with
IEEE 1394 Board.
Problem with Hard
Disk.
The entered pass-
word is incorrect.
USB has a problem.
Hardware Problem:
Ethernet
You do not have
the privileges to
use this function.
Authentication
has failed.
Parallel I/F board
has a problem.
Printer font error.
52
Cause
• IEEE 802.11b interface
unit was not inserted
when the machine was
turned on, or it was
pulled out after the
machine turned on.
• The settings are not
updated although the
unit is detected, or er-
rors are found while
accessing the unit.
An error may have oc-
curred in the IEEE 1394
board.
An error has occurred in
the hard disk drive.
The password of the en-
crypted PDF file has been
entered incorrectly.
An error has occurred in
the USB interface.
An error has occurred in
the Ethernet board.
Use of this function is re-
stricted.
• The login user name
or password entered
is incorrect.
• The machine current-
ly cannot perform au-
thentication.
An error has occurred in
the parallel interface
board.
An error has occurred in
the font settings.
Solution
Turn off the machine and check the
IEEE 802.11b interface unit is inserted
correctly. Then, turn the machine on
again. If the message appears again, call
your service representative.
Turn off the main power switch, and back
on again. If the message appears again,
contact your service representative.
Turn off the main power switch, and back
on again. If the message appears again,
contact your service representative.
Enter the correct password.
Turn off the main power switch, and back
on again. If the message appears again,
contact your service representative.
Turn off the main power switch, and back
on again. If the message appears again,
contact your service representative.
Contact the administrator.
• Check your login user name and
password.
• Contact the administrator.
Turn off the main power switch, and back
on again. If the message appears again,
contact your service representative.
Contact your service representative.