Configuring Port Parameters - Enterasys VH-2402S Management Manual

Configuring Port Parameters

Use the Port Configuration menus to set or display communication
parameters for any port or module on the switch.
<APPLY> <OK> <CANCEL> <PREV Unit> <NEXT UNIT> <PREV PAGE> <NEXT PAGE>
Parameter
Type
Admin
Flow Control
Speed and Duplex
9033645-01
Vertical Horizon Local Management -- VH-2402S
Port Configuration : Unit 1 Port 1-12
Port Type
-------------------------------------------------------------------------
1. 10/100TX
2. 10/100TX
3. 10/100TX
4. 10/100TX
5. 10/100TX
6. 10/100TX
7. 10/100TX
8. 10/100TX
9. 10/100TX
10. 10/100TX
11. 10/100TX
12. 10/100TX
Use <TAB> or arrows keys to move. <Space> to scroll options.
Figure 2-20. Port Configuration
Default
ENABLED
DISABLED
AUTO
Admin Flow
Control
ENABLED ENABLED 10-HALF
ENABLED ENABLED 100-FULL
ENABLED ENABLED AUTO
ENABLED ENABLED AUTO
ENABLED ENABLED 10-FULL
ENABLED ENABLED 100-HALF
ENABLED ENABLED AUTO
ENABLED ENABLED AUTO
ENABLED ENABLED AUTO
ENABLED ENABLED AUTO
ENABLED ENABLED AUTO
ENABLED ENABLED AUTO
Description
Shows port type as:
10/100TX : 10Base-T / 100Base-TX
100FX : 100Base-FX
1000SX : 1000Base-SX
1000LX : 1000Base-LX
Allows you to disable a port due to abnormal
behavior (e.g., excessive collisions), and then re-
enable it after the problem has been resolved.
You may also disable a port for security reasons.
Used to enable or disable flow control. Flow
control can eliminate frame loss by "blocking"
traffic from end stations or segments connected
directly to the switch when its buffers fill. Back
pressure is used for half duplex and IEEE 802.3x
for full duplex. Note that flow control should not be
used if a port is connected to a hub.
Used to set the current port speed, duplex mode,
and auto-negotiation. (Auto-negotiation is not
available for 100Base-FX ports.)
Speed and
Duplex
VH-2402S User Interface 29