Ip Connectivity Test (Ping) - Enterasys VH-2402S Management Manual

Parameter

IP Connectivity Test (Ping)

Use the IP Connectivity Test to see if another site on the Internet can be
reached. The screen shown below is described in the following table.
Use <TAB> or arrow keys to move, other keys to make changes.
Parameter
IP Address
Test Times
Interval
Success/Failure
9033645-01
Default Description
BOOTP Get IP - IP is enabled but will not function
Vertical Horizon Local Management -- VH-2402S
Network Configuration: IP Connectivity Test (Ping)
IP Address : 200.123.211.109
Test Times : 1
Success : 0
[Start]
<OK>
Figure 2-9. IP Connectivity Test
Description
IP address of the site you want to ping.
The number of ICMP echo requests to send to the specified site.
Range: 1~1000
The interval (in seconds) between pinging the specified site.
Range: 1~10 seconds
The number of times the specified site has responded or not to
pinging.
until a BOOTP reply has been
received. BOOTP requests will
be periodically broadcast by the
switch in an effort to learn its IP
address. (BOOTP values can
include the IP address, default
gateway, and subnet mask.)
Interval : 3
Failure : 0
VH-2402S User Interface 17