Connecting To A Vt Series Terminal; Connecting An Ibm Pc Or Compatible - Enterasys 6H308-48 Hardware Installation Manual

4. Turn on the PC and configure your VT emulation package with the following
parameters:
Parameter
Mode
Transmit
Bits Parity
Stop Bit
5. When these parameters are set, the Local Management password screen will display.
Refer to the appropriate Enterasys Matrix DFE‐Gold Series Configuration Guide for
further information.
Figure 3-9
1 UTP straight-through cable with RJ45 connectors
2 RJ45 COM port

Connecting to a VT Series Terminal

To connect a VT Series terminal to an Enterasys Networks DFE module COM port
(Figure 3‐10), use a UTP straight‐through cable with RJ45 connectors and an RJ45‐to‐DB25
female adapter, and proceed as follows:

Connecting an IBM PC or Compatible

à Â
Matrix DFE-Gold Series PoE Module 4H4285-49 Installation Guide 3-19
Connecting to COM Port for Local Management
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
Á
À
3 RJ45-to-DB9 PC adapter
4 IBM PC or compatible device