Enterasys 6H308-48 Hardware Installation Manual page 61

Table 4-1 LANVIEW LEDs (continued)
LED Color
RX/TX Indications in Standard Mode
RX Off
(Receive)
Green
Amber
Red
TX Off
(Transmit)
Green
Red
State
No link. No activity. Port
enabled or disabled.
Solid. Link present, port
enabled, no traffic is being
received by the interface.
Flashing. Link present, port
enabled, traffic is being
received by the interface.
Blinking. Indicates
collisions. This indication is
only supported on 10/100
ports.
Port enabled, but no activity.
Flashing. Indicates data
transmission activity. Rate of
flashing indicates the data
rate.
Flashing. Fault or Error
(collision).
Matrix DFE-Gold Series PoE Module 4H4285-49 Installation Guide 4-5
Recommended Action
None.
None.
None.
Contact Enterasys Networks for
technical support.
If it is known that the port should be
active and is not, contact Enterasys
Networks for technical support.
None.
None, unless there is a high rate of
activity. In this case, check for network
configuration problems or a defective
device.
Using LANVIEW