Completing The Installation; Completing The Installation Of A New System - Enterasys 6H308-48 Hardware Installation Manual

Completing the Installation

Modem Port Adapter Wiring and Signal Diagram
RJ45
Pin
1
2
4
5
6
8
Completing the Installation
Completing the DFE module installation depends on if the module is being installed in:
• a new DFE module system (refer to "Completing the Installation" on page 3‐24), or
• an established, operating DFE
of a DFE‐Gold Module in an Existing System" on page 3‐26).

Completing the Installation of a New System

In a new system of DFE modules, one of the installed DFE modules will become the
management module on chassis power up, and all DFE modules will automatically be set
to the factory default values. A complete list of the factory default values are provided in
Chapter 3 of the Enterasys Matrix DFE‐Gold Series Configuration Guide.
After installing all DFE modules into the host chassis and making the connections to the
network, proceed to "First‐Time Log‐In Using a Console Port Connection" on page 3‐25 to
access the module management startup screen from your PC, terminal, or modem
connection.
3-24 Installation
DB25
Conductor Pin
Blue 2
Orange 8
Red 3
Green 7
Yellow 20
Gray 22
module system (refer to "Completing the Installation
Signal
Transmit (TX)
Data Carrier Detect (DCD)
Receive
Ground (GRD)
Data Terminal Ready (DTR)
Ring Indicator