Table of Contents
Advertisement
ELECTRICAL HAZARD: Only qualified personnel should install the 2H252-25R.
NOTE: Read the Release Notes shipped with the device to check for any exceptions to
the supported features and operation documented in this guide.
This chapter provides the instructions required to install the 2H252-25R. A Phillips screwdriver is
required to install options into the device or install the device into a rack. Follow the order of the
sections listed below to correctly install the device.
•
Unpacking the Device
•
Installing Options
•
Installing the Device (on a shelf or tabletop, or into a standard rack)
•
Connecting to the Network
•
Completing the Installation
3.1
UNPACKING THE DEVICE
Unpack the device as follows:
1. Open the box and remove the packing material protecting the 2H252-25R.
2. Verify the contents of the carton as listed in
(Section
3.1)
(Section
3.2)
(Section
3.4)
(Section
3.5)
Table
3-1.
Installation
(Section
3.3)
Installation
3
3-1
Advertisement
Table of Contents
Troubleshooting
